> Top is VE.A , Bottom is VE.A 2nd.
> Top & PCB & Plate remove.
The central PC(polycarbonate) design has changed dramatically.
No more resonant sounds.
> PC(polycarbonate) remove.
A hall to hold an oblique object.
> Bottom remove.
> The Oblique object has 3 patterns.
However, I recommend only two patterns. (pattern 3 is please take it for fun.)
1. traditional usage / Creates a downward slope from the back to the front.
2. recommended use / creates a downward slope from the inside out.
3. special usage / creates a downward slope from outside into.
I think it is wrong to use this.
But it would be nice to use it with the VE.A Stand.
…. a little more
You can also adjust the height of the sloped object.
about 9 degrees
about 11 degrees
– fin –